Leprecon LPC V2 User's Manual Manuel d'utilisateur télécharger pdf (Page 33)

LPC 48 / 96 Users Manual

Page 33

4 Stage View - Manual Channels

The LPC allows manual channel control using front panel faders. Channels

beyond the fader range are set using the video interface or keypad, and are

referred to as Virtual Channels.

The Manual Fader on the left side of the fader banks controls the output of the

desk channel faders. Getting output from the manual scene requires the Grand

Master and the Manual fader to be up. LPC must be in Run Mode to see Stage

view. Submaster Run and Cue Run controls and features are similar.

4.1 Using Channel Faders

Operation of the desk channel faders are chosen in the Settings screen, (see

section 3.3.1.) The desired use of the desk faders is selected by either Wide

Mode or Two Scene Preset Mode. The Fader Mode key, located above the

manual fader, is a secondary control of the operation, (See Figure 18).

The two banks of faders can be used in the following ways:

Wide Mode

 Fader Mode – Manual: all desk channel faders are used as a single scene.

The manual fader has control over the desk and virtual channel output.

 Fader Mode – Subs: the lower bank faders are Submasters only, and the

manual fader does not affect their output. The upper bank and virtual channel

outputs are controlled by the manual fader.

Two Scene Preset Mode

 Fader Mode – Manual: upper and lower bank of desk channel faders are set

as two separate scenes. The manual fader is used to crossfade between the

two scenes, and the virtual channels are not affected.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 121 122

Pas de commentaire

Leprecon LPC V2 User's Manual Manuel d'utilisateur Page 33